Suppressing a Group 1

[CTLReporting]

To all:

Is there a way to suppress a group header if there is only one group? I want the Group Header to show if there is more than one group, but if not, I don't want it to show the header for just one group. Any input would be helpful.

Thank you,


CTL Reports Group,
Running Crystal Reports 8.0 and 8.5
Bentonville, AR
FoodLabReports@ctlusa.net

 

[lbass]

Go to format section->group header->suppress->x+2 and enter:

distinctcount({table.groupfield}) = 1

...where {table.groupfield} is the field you are grouping on.

-LB

 

[CTLReporting]

Thank you, but my formula editor has a x-2 button not an x+2 button

=O)

Thanks again, it worked great!

CTL Reports Group,
Running Crystal Reports 8.0 and 8.5
Bentonville, AR
FoodLabReports@ctlusa.net

 

[lbass]

For a minute there, I thought I was still getting it wrong--for a long time I was calling it the E2 button, and I don't have a clue where I got that. But try a magnifying glass, there really is a "+" there in the middle. At least in 8.0!

-LB

 

[CTLReporting]

I set my resolution to 640x480 and I saw the plus sign! Ha! I'm blind! Good job having great Eye-sight. I would have replied to this earlier, but on setting the resolution back to original, I went one past and into the out of range section of 1280x1024 and i had to restart in VGA mode to change it! haha.

CTL Reports Group,
Running Crystal Reports 8.0 and 8.5
Bentonville, AR
FoodLabReports@ctlusa.net