Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Strange TTY Output

Status
Not open for further replies.

NY105

Technical User
Jul 6, 2011
41
US
Hello All,

I have allot of "000000" output to my TTY's at random. This seems to be more prevelant as the day goes on as calls increase. I already disconnected all my TTY's one at a time to see if was a TTY issue and it's not. I suspect something with CNi or 3PE since in LD 135 it has OOS messages and 0 = CP local bus parity threshold exceeded. OK, if I am on the right track, what does that mean and where do I go to fix it or can I?
 
Sorry for not responding been TDY for a week. I am still having this problem, any other thoughts on this would be greatly appreciated.

Thanks
 
well:

patches, SCPU, INI, relaod

hard to tell, are these showing up all at once, or are they building up

0....then some time later you get another 0 on the same line?

or do the "0" show up all at once 00000000

check if you are Line mode off? LOF vs LON

try also at the OVL000 prompt SEND OFF (turn off send command from other terminals, but you will not get messages from other, try it to test)




__________________________________________________________
Find a job you love and you'll never work a day in your life. - Confucius
 
All the patches are up to date, INI'd the PBX and did reload. The 0's whould show up in groups of four.
example: 0000 or 0000000000000000

but always in groups of four no matter if on the same line. How/where would check the LOF and LON and the prompt SEND OFF?

Thanks
 
in the OVL000 prompt.

are you getting those "0"s on J21 or J25 off the active cpu? (or com1/2 off the faceplate)

__________________________________________________________
Find a job you love and you'll never work a day in your life. - Confucius
 
I am directly connected to J21 on the active cpu and still get the same results.
 
You should be on J25 for a terminal connection, J21 is the modem connection
 
Set your terminal up for 9600/7/2/mark and see if it goes away.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top