Steps to add ASM

[sidroski]

What are the steps for adding ASM? Can't draw DT. What am I doing wrong? It is in Mod 3.
Thanks in advance

 

[cook1082]

You have to program in hardware section that mod 3 is an ASM.

 

[sidroski]

I did but not getting D.T. Shows ASM in Hardware. Shows empty in Maint. Prov. Disabled and enabled it. Still shows empty.

 

[HughRunyan]

Check for voltage on the W/Bl pr I have and amp that the screw hold the amp out just fare enough to keep it from working also some of the older software the pen out is not what you would think it would be if you do not have voltage and the amp is conx you have a bad mod

 

[cook1082]

Try another slot on the exp cart.

 

[sidroski]

Thanks to all for the info. Turned out it was the fiber. I had good light coming out of it and the asm but it was used and must have gotten bent when the system.

This thread can be closed.