STEP BY STEP FOR T1 AND ISDN-PRI

[PERRYPJ]

Been looking on the Avaya Site for a PDF that tells you how to set up a T1 and ISDN-PRI from the ground up but I have not run across anything. Nortel had some pretty good manuals of how to set up features, and I was hoping to find something like that with Avaya. Does anyone know if there is such a thing

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[uzumaki]

1. Add DS1 #### (Setup the parameters for line coding, framing mode, signaling mode, connect, Interworking Message, Interface companding, country protocol, Protocol, version, CRC and Splip detection
2. Create signaling and define the ds1 port
3. Create trunk and define the DS1 board port in step 1.
4. Go back to step 2, and add the trunk group name you created in step 3.
5. add route pattern
6. define incoming call handling treatment
7. modify the public unknown numbering