Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Start-Up Problems

Status
Not open for further replies.

latinj

Vendor
Dec 1, 2005
65
US
I have a switch that i got out of my storage to program ,it is a NORSTAR PLUS MODULAR ICS r 4.1 and in the first slot I have a FIBER MOD. and the second is blank and the next 2 are DS MOD. My problem is when I plug a phone into the switch the phone just has blinking triangles next to all the buttons on the set , so any help greatly appreciated
 
DS MODS - presume you mean Line Cards
FIBER MOD - Presume you mean Fiber Expansion Card

Sounds like the system was not put back the way it was and cannot see the modules it had on it.

Try install a lower software





=----(((((((((()----=
curlycord
 
Some how the T-1 card disappeared so is there a way to reset switch with out the card and start from the beginning
 
Yeah, it sounds like the fiber card is in the wrong slot. From right to left, you should have no open slots. You'll need XC sw to support an additional fiber card in slot 1.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top