SRG/BCM50 Routing 3

[mikerroy]

Can anyone help us with an issue we are having with an SRG/BCM50? We are trying to route the analog station lines on the SRG across SIP to the host PBX a CS1000 to go out the PRI's on this PBX.We are on a 5 digit dial plan with 7 front ending all of our numbers. We have 7A as a destination code pointing to route 1 (SIP). Calls continue to route out the local analog trunks on the SRG.
Any help with this problem would be greatly appreciated.
ThanksMikerroy

 

[56BelAir]

why are you trying to route the local analog trunks? they are supposed to be local trunks and not route to the main PBX.

 

[mikerroy]

We are not trying to route the analog trunks, we want the 4 analog "Lines" to route across SIP to the CS1000 and use the PRI's at that location. We are trying to assign DID numbers to the 4 analog lines on the SRG. These line will be used for fax and credit card readers. We want to cut back to one analog trunk for just 911 and emergency out bound calls.

56BelAir thanks for responding
Mikerroy

 

[56BelAir]

Its been a long time since I did one of these but I would imagine the process would be simular to the incoming route from the CS1000 to the SRG but just reversed.
So I would setup a destination code (7) to use voip trunk route on SRG and delete 1 digit with external number(9).
On your CS1000 route LD 16 make sure you have INAC set to yes.

 

[impala]

Are you able to add sets to a SRG BCM?

 

[cook1082]

If I remember you have to forward the lines. Look for that in the docs.