SPU2 and Ethernet

[spacer73]

What cable to be connected on ethernet port of SPU2 board?
The cable TSR 902 0240, works with NIU, but does not work with SPU2.
SPU2 configuration through V.24, adjustments keeps. Ping to Ethernet address SPU2 do not go, in ipstat of a mistake on input.

System BC11SP10

Andy

 

[whosrdaddy]

sorry Andy but the NIU eth cable DOES work on spu2. do you work via a switch/hub or is it connected directly to your pc(in this cas you must have crossover cable)?
ip parameters can be changed on V24 port via config. after config do not forget to issue "run 8" command.

greetings,

http://www.damovo.com

 

[spacer73]

Thank you! Work fine after "run 8" command.

> sorry Andy but the NIU eth cable DOES work on spu2.
Yes.

> do you work via a switch/hub or is it connected directly to your pc(in this cas you must have crossover cable)?
Working via hub <10Mb> and working fine.

> ip parameters can be changed on V24 port via config.
Yes.

> after config do not forget to issue &quot;run 8&quot; command.
Yes, I don't know this command and not found it in documenetations. After this command all work.

Andy

 

[mdfan]

run 8 is in ALEX .