SPEXI with NDC

[serg75]

Hi!
I have a problem with non-dialled connection extension function. When I make execution of command SPEXIIR=1000,OPT=N,NDC=9; and I lift a handset from ext. 1000, the system ejects an error "VACANT NUMBER". I have some prefixs, which one start with digit 9 (i.e. 90, 91, 92... 97, 99), and also 98 is LCR. If in quality NDC put in example 90 (i.e. 9x), all will work correctly. But it is necessary to use NDC=9. Also it is possible to make false DEST (001 for example) and to make NDC=001 is will work, but then for 001 it will be necessary to adjust whole NADAP.
Why all this takes place and how it is possible to decide this problem?
I use following parameters:

ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
99 SL60 H'00000210 H'11400000 H'06410020 NO

ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
99 011000990000001 5 1001000001 0 30 128 01070701 111110000030 111111

EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
90 99 1006000000000250000 0 2 0

EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
91 99 1006000000000250000 0 2 0

..........

EXTERNAL DESTINATION CODE 90 - 97, 99

LEAST COST ROUTING ACCESS
CODE NUMBER SERIES 98

.........

KEY SYSTEM CATEGORY PRINT
DIR TRAF SERV CDIV ROC ITYPE TRM ADC LANG
1000 01151515 02151207 011151000 000001 21 0 00100000010 F

System is BC10 CNA141.

 

[GioBs]

Which is your goal? what do you want that happen when off-hook the telephone?

 

[serg75]

Would be fine to hear dial tone from PSTN (or from MD110). But because D1=1 in ADC, that means "silence" as response, and that's no so good... But why "vacant number"?

 

[gedii]

Hi Serg75

The reason I feel that this is resulting in "Vacant Number" is due to the fact that the MD110 deems the request for simply a '9' as kind of incomplete and ambiguous in your switch. This is because, as you said, the actual 'ED' or 'LCR' codes defined in NADAP are expanded to the 9x format.

What I'm suggesting is that if for instance the entire digit '9' was defined as either an 'ED' or 'LCR' in NADAP, you'd probably find that your scenario would work.

I don't know if there are any Parameters or Patches that could help in overcoming this problem unfortunately.

Best Regards

gedii

 

[DUFQI]

NDC" has to be part of "NADAP" (EX,DE,...)
Your problem is the LC Routing Access. Without this, you could have "9" as "ED" and different RODDI's starting with "9".

 

[serg75]

O.K. guys
I can make so that MD generated the own dial-tone after the fixed least cost routing access code (LAC) will be dialled?

 

[whosrdaddy]

check aspap 104 for that

http://www.damovo.com

 

[serg75]

Aspap 104 force generate dial-tone for all LACs. But may I make it for FIXED LAC?