Speed and duplex settings of ITG card

[tikiturtle]

How can I tell what speed and duplex settings are on my ITG card. Can this be done by dialing into the switch - any specific LD command?

Much Thanks,

 

[ineo06]

If you have the serial cable for your itg set your pc at 9600 8 1 none and restart your ITG.
In the startup i think you can read all about you search.

Good luck

 

[johnpoole]

post is right, there is a interface port on that card for direct connection, it could be connected to a modem but to boot the card your still going to need fingers in the switchroom

john poole
bellsouth business
columbia,sc

 

[Pudge99]

If you are able to telnet to the ITG card via OTM or Procomm, enter the command, itgCardShow (case sensitive). Will list card information, including E-Lan and T-Lan speeds and duplex.

 

[MG2005]

yeah telnet to the card theres alot of good functionality and commands in there. i can do almost anything remotely to the ITG trunk and line cards and find out anything about them and the phones connected to them

 

[srmega41]

Doesn't OTM give you the ability to do that from the IP Trunk screen? I seem to remember being able to right-click on the ITG node, and an option to telnet to the card was there.

It has been a few years, and this may have changed since I worked on them.

Scott M.

 

[Pudge99]

YES; OTM does give you the ability to directly telnet to the ITG card.

 

[tikiturtle]

Thanks for all your responses guys - I am gonna jump in OTM tomorrow and check it out!!