Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Solaris 10 - Format and verify duration ???

Status
Not open for further replies.

scorney

Technical User
Sep 15, 2003
115
CA

How long should take format & Verify?

I am running this command below since 21 hours and it is still running...
It's a T5220 e/w 4 x 300 GB HD. I want to install Solaris 10.

format> format
Mode sense page(4) reports rpm value as 0, adjusting it to 3600
Ready to format. Formatting cannot be interrupted.
Continue? y
Beginning format. The current time is Wed Jul 31 09:33:31 2013

Formatting...
Mode sense page(4) reports rpm value as 0, adjusting it to 3600
done

Verifying media...
pass 0 - pattern = 0xc6dec6de
42457/27/63

Please let me know,
There must be a quicker way to do this.... Is it the rpm at 3600? if so how to make this higher speed???
Thanks!
 
AVAILABLE DISK SELECTIONS:
0. c1t0d0 <LSILOGIC-LogicalVolume-3000 cyl 65533 alt 2 hd 32 sec 279>
/pci@0/pci@0/pci@2/scsi@0/sd@0,0
1. c1t2d0 <LSILOGIC-LogicalVolume-3000 cyl 65533 alt 2 hd 32 sec 279>
/pci@0/pci@0/pci@2/scsi@0/sd@2,0
Specify disk (enter its number): 0


It`s up to:
Verifying media...
pass 0 - pattern = 0xc6dec6de
56472/2/252

So the Number found in the HD or show-disks from the OK prompt is the Cyl = # of pattern

On my case 65533 and pass 0 & Pass 1, very long process :)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top