SNMP Trap Watcher

[thembaz]

Can't get SNMP Traps working or sending to port 162 from Avaya CS1000 PABX. The SNMP Trap Watcher has error on port 162.

 

[allenmac]

After you define the SNMP settings, you must backup the database for the changes to be put into production. (LD 43 --> EDD).

 

[thembaz]

Thank you, but I have done that part on the PABX. I have configured two different IP adresses as the destination or listener, but do I prove CS is sending. I am using SNMP Trap Watcher (see below)to test on both the servers and I get the message "error binding to Trap Port (162), it may already be in use". How can I test this, have already restarted those servers to get make sure nothing is using that port.

SNMP Trap Watcher
Version: 1.36
Author and Copyright: 1998-2001, BTT Software, All Rights Reserved

This version of SNMP Trap Watcher is provided as FREEWARE, and consequently,
there is only limited email support provided.

website:

http://www.bttsoftware.co.uk/

 

[allenmac]

This sounds like a problem with the receiver, not the PBX.

You can send test alarms from LD 117 as follows:

LD 117
=> test alarm INI 001

This will send an INI001 Alarm with the text 'This is a test'.

You will need to determine if there is already a SNMP service running on the server that is already bound to port 162 - most likely one of the default Microsoft SNMP services.