I "lucked" into a Merlin Classic setup that I was "planning" to install for my home office/home use. I have more phones than I need available to me so all I needed to do was figure out how to hook it up. Thanks to your forum and a lot of string perusal I was able to locate all the install info I needed. I set about the task and after plugging in the 410 control unit I was getting my patch cords lined up when I detected the ominous high pitched squeeel of something frying. Then the smoke. Now what?
Some of the online suppliers don't support the unit due to it's high mortality rate. Some sell them refurbished for $200 and some for $400. Can I get mine fixed or can I find replacement parts? I opened the unit and the board that the ribbon cord from the power supply attaches to is the part that cooked. Right next to (above) the connector pins from the ribbon cord on the board there are two round components. Each has two legs. It was one of these components that fried. Suggestions?
Will the Merlin Plus control unit work with the phones from the 410 system? I was hoping to salvage what I can for as little outlay of cash possible. The good news is I found this forum, where I think I'll find the help I need!
Jim Bock
Bocksbox@hotmail.com
Some of the online suppliers don't support the unit due to it's high mortality rate. Some sell them refurbished for $200 and some for $400. Can I get mine fixed or can I find replacement parts? I opened the unit and the board that the ribbon cord from the power supply attaches to is the part that cooked. Right next to (above) the connector pins from the ribbon cord on the board there are two round components. Each has two legs. It was one of these components that fried. Suggestions?
Will the Merlin Plus control unit work with the phones from the 410 system? I was hoping to salvage what I can for as little outlay of cash possible. The good news is I found this forum, where I think I'll find the help I need!
Jim Bock
Bocksbox@hotmail.com