SMDR problem

[CHRIN1]

Dear,

I can't print the message SMDR out form my PABX (bc11sp08)at all event i try to check the command as belows:
<cinip;
COMMAND UNKNOWN
<ioddp;
I/O DEVICE DATA
NODE IODEV/SUBFS BPOS/EQU SIPOS TYPE/USAGE STATUS AUTH
SYS 001-0-60 - - IN SERVICE
SYSN SYSDISK1 001-0-60-0 3 ADTX IN SERVICE
SYSSUBFS11
SYSSUBFS21
SYSN SYSTERMINAL 001-0-60-1 - MML - 7
SYSN PCINTERFACE 001-0-60-2 - MML - 7
SYSN SMDR 001-0-60-3 - OUT IN SERVICE
SYSN TELNET 001-0-60-4 - NETWORK/MML 7
END

<ioifp;
I/O INTERFACE CHARACTERISTICS
IODEV IFACE BAUDR WORDL PARITY STPBIT PROC
SYSTERMINAL V24 ALL 8 NONE 1 ECHO
SMDR V24 2400 7 EVEN 1 ECHO
PCINTERFACE V24 ALL 8 NONE 1 ECHO
END
<iofdp;
I/O FUNCTIONS DEFINITION
IODEV TRD NDC CALLS WAIT DELAY SUPER
SYSTERMINAL BOTH 2 30 5 YES
SMDR BOTH 2 30 5 YES
PCINTERFACE BOTH 2 30 5 YES
END
<clinp;
CALL LOGGING DATA
CALL LOGGING MODE: ACTIVATED
MOBILITY LOGGING MODE: NOT ACTIVATED
HEADER FORM DMPSIZ DISCR IN SERVICE LOGABN HRTBT
SMDR01 2 1 0 Yes NO NO
ORIG DIAL TIME
ALL 0 -9 ALL
DIR LIM BPOS EVENT
END

kindly help about this, and do i need to change the configuration because i received nothing by hypetherminal connection.

Best regards,

 

[megglesfield]

No such command as CINIP exists!!
What data are you trying to print out? Call logging commands for SMDR all begin CL.

 

[DUFQI]

Hi,
would be helpfull to have "CLDFP".
There seems to be nothing connected to port 3 of NIU or the parameters of your PC don't correspond to the parameters in "IOIFP".
regards
DUFQI

 

[lalrl]

Did it work before? Do you have connected the right cable:

TSR...0459, crossovercable, maybe 1:1-Adapter 24 to 9PIN, and do not use gender-changer!

 

[CHRIN1]

Dear,

Now i can retrie all data to my PC but i still misunderstanding on
<Cldfp;
FILE ADMINISTRATION DATA
FILE STATE
SMDR01 ACT
IODEV/PATH USER DEVICE STATE PRIORITY
SMDR CIL-1 READY/STARTED C
END

Could you tell me when i disconnect the cable the device state was return to passive so even i try to replug it still in passive state. do we have command to resold?
any way does SMDR data can be store in PABX hard disk?

Thanks for your help
chrin