SMDR Help via MP

[imbinary]

Hello,

I have a NEC 2000ips software version 3000 that we are trying to setup SMDR on port 0 of the MP which was being used for matworx (now setup to use IP). I have followed the steps posted here and in the manual as follows.

4000>0>14
4001>0>1
4002>0>1
4003>0>1
4004>0>0
4005>0>1
4006>0>1
4008>0>4
1306>XXXX>1
410>03
1305>XXXX>0
3549>ZZ>0
08>463>0
08>040>0
08>803>0
where XXXX is each extension and ZZ is each trunk.

This is going to the same PC, com port, and cable that we used for matwork so I know they all work. But, using hyper-terminal set to 9600-8-n-1 I get no output from the MP.

I'm probably just missing something simple but not sure what it is. Anyone have any ideas on what could be my problem?

 

[grh959]

Try command 3514 for your outbound routes......

 

[imbinary]

ahh sorry I skipped that when typing it out.

3514>ZZ>1 (this is default but I set anyway)is done as well.

 

[grh959]

I do not think the cable used for Matworx will work:

(1) MP Built-in SMDR on RS-232C
MP card
RS RVS-4SCA-C/RS RVS-15S CA-A or RS NORM-4S CA-A

 

[imbinary]

Thanks

I'll order one and give it a shot.