I have a COMPAQ Armada 7800 Notebook computer Model 6300/T/8000/V/0/3 running Windows 2000 Professional. I am trying to install a Microtech SmartMedia Car Reader/writer into to USB port of the laptop. This is a small plug/unplug type device the is used to read SmartMedia from my digital camera.
I have loaded the lastest software/drivers from Microtech, upgraded Windows 2000 to Service Pack 2, upgrade my notebook BIOS to the latest from COMPAQ.
The problem: After all the above was completed, I then plug the SmartMedia Car Reader/writer into the USB post. The computer senses it's presents, goes thru an install routine to the USB port, then BLUESCREENS and reboots. It will cycle BLUESCREENing and rebooting until I unplug the device at which time it boots properly. However, I am not able to use the device.
I have contacted both COMPAQ and Microtech ( about this problem to no avail. Any suggestions??? Thanks for any.
Feltsoles
I have loaded the lastest software/drivers from Microtech, upgraded Windows 2000 to Service Pack 2, upgrade my notebook BIOS to the latest from COMPAQ.
The problem: After all the above was completed, I then plug the SmartMedia Car Reader/writer into the USB post. The computer senses it's presents, goes thru an install routine to the USB port, then BLUESCREENS and reboots. It will cycle BLUESCREENing and rebooting until I unplug the device at which time it boots properly. However, I am not able to use the device.
I have contacted both COMPAQ and Microtech ( about this problem to no avail. Any suggestions??? Thanks for any.
Feltsoles