harrisonconsult
IS-IT--Management
Hi,
I have a Proliant 3000 with Smart Array 3200 controller 4x18Gb disks. 2 partitions 1 system (I can afford to trash this) and a data partition (this data must stay 100% intact). After changing the default locale on NT and a reboot later I got an error message about a missing file and to reinstall NT and repair. I did as instructed and when I boot my I'll get the following NT error message; "The system did not load because of a computer disk hardware configuration problem." and now I cannot get back into the server. I have tried to reinstall a new existence of NT and F6 the Compaq smart array drivers but still I get the same message all I simply need to do is boot into NT and pull all the data off the data partition onto another server then I can flat line the lot and start again any ideas how achieve this.
Any assistance much appreciated.
Regards
Mark
I have a Proliant 3000 with Smart Array 3200 controller 4x18Gb disks. 2 partitions 1 system (I can afford to trash this) and a data partition (this data must stay 100% intact). After changing the default locale on NT and a reboot later I got an error message about a missing file and to reinstall NT and repair. I did as instructed and when I boot my I'll get the following NT error message; "The system did not load because of a computer disk hardware configuration problem." and now I cannot get back into the server. I have tried to reinstall a new existence of NT and F6 the Compaq smart array drivers but still I get the same message all I simply need to do is boot into NT and pull all the data off the data partition onto another server then I can flat line the lot and start again any ideas how achieve this.
Any assistance much appreciated.
Regards
Mark