Smart Array 3200 Controller Issue

[Tracknut]

Had replaced a bad 3200 ctrl with a new one and after rebooting received a 1789 Post error (drive not responding...drive had orange light). I hit f1 which disabled the drive array. So now when I put in a new drive and go into the array config. utility it says there are no array ctrls detected. I'm assuming it's because of selecting f1. How do I enable it?

 

[itsp1965]

Don't you have the option to access the system partition by pressing F10. From there you should be able to set the raid controller as the primary boot controller.

 

[Tracknut]

I do have the F10 option. The server boots up fine right now so I was afraid to select the raid ctrl as the boot up.
I'll have to give that a shot.