Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Small Office & Prologix

Status
Not open for further replies.

MERIDIAN11C

Programmer
Mar 19, 2004
215
MX
Hello
does any one has a guide to configure an Small Office and Definity prologix with IP Trunk ?

please contac me at lrodriguez71@hotmail.com
 
One could look at previous posts but then again I am probably just being mean.
 
On a side note, I worked with a fellow over at the Nortel forum here at tek-tips.com With his help and his Nortel setup we were able to connect an IPO 406 and a Nortel 81c via QSIG trunking.

I love this place!
 
thanks CarGoSki
but in the prologix i dont have Qsig
it is posible to connect Prologix version 12 and small office via IP Trunk ?

thanks again
 
Read the Avaya tip on using centralized AUDIX. It has the stuff you need to network the two in it.
 
We have a Prologix talking to some IP 401 NG this way:

Prologix IP Trunk configuration:[tt]
TRUNK GROUP

Group Number: 66 Group Type: isdn CDR Reports: y
Group Name: IP401ng COR: 5 TN: 1 TAC: *27
Direction: two-way Outgoing Display? y Carrier Medium: IP
Dial Access? y Busy Threshold: 99 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n TestCall ITC: rest
Far End Test Line No:
TestCall BCC: 4
TRUNK PARAMETERS
Codeset to Send Display: 0 Codeset to Send National IEs: 6
Max Message Size to Send: 260 Charge Advice: none
Supplementary Service Protocol: a Digit Handling (in/out): enbloc/enbloc

Trunk Hunt: cyclical QSIG Value-Added? n
Digital Loss Group: 18
Incoming Calling Number - Delete: Insert: Format:
Bit Rate: 1200 Synchronization: async Duplex: full
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0

TRUNK FEATURES
ACA Assignment? n Measured: none Wideband Support? n
Internal Alert? n Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n
Suppress # Outpulsing? n Format: public
Outgoing Channel ID Encoding: preferred UUI IE Treatment: service-provider

Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: n
Modify Tandem Calling Number? n
Send UUI IE? y
Send UCID? n
Send Codeset 6/7 LAI IE? y



SBS? n Network (Japan) Needs Connect Before Disconnect? n

TRUNK GROUP
Administered Members (min/max): 1/2
GROUP MEMBER ASSIGNMENTS Total Administered Members: 2

Port Code Sfx Name Night Sig Grp
1: T00147 66
2: T00211 66
3:
4:
5:
6:
7:
8:
9:
10:
11:
12:
13:
14:
15:

[/tt]

Prologix signaling group configuration:

[tt]
SIGNALING GROUP

Group Number: 66 Group Type: h.323
Remote Office? n Max number of NCA TSC: 2
SBS? n Max number of CA TSC: 2
Trunk Group for NCA TSC: 66
Trunk Group for Channel Selection: 66
Supplementary Service Protocol: b
T303 Timer(sec): 10

Near-end Node Name: C-Lan Far-end Node Name: IP401ng
Near-end Listen Port: 1720 Far-end Listen Port: 1720
Far-end Network Region: 2
LRQ Required? n Calls Share IP Signaling Connection? n
RRQ Required? n
Media Encryption? n Bypass If IP Threshold Exceeded? n

DTMF over IP: out-of-band Direct IP-IP Audio Connections? y
IP Audio Hairpinning? y
Interworking Message: PROGress
[/tt]

IP Office Line -> VoIP configuration
[tt]
Gateway IP Address: (IP address of Prologix C-Lan)

Compression Mode: G.723.1 6K3 MP-MLQ

H450 Support: QSig

Enable FastStart: On
Out of Band DTMF: On
Allow Direct Media Path: On

All others: Off
[/tt]

Also remember to properly set:
[tt]
On Prologix:
- node-names
- ip-codec-set
- ip-network-region
- AAR or ARS according to your dialplan


On IP Office:
- Incoming Call Route
- Local or Global Short Code
[/tt]

Good luck
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top