Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

slow ftp performance

Status
Not open for further replies.

boczon

MIS
Dec 28, 1998
5
US

Has anyone seen very slow ftp performance when trying to move data from a lower security zone to a higher one??
 
Are you using the IDENT protocol? If so, use configure the "service resetinbound" command.

Also, verify that there is a reverse DNS entry for the ftp server. Hope this helps!
 
I've seen this. Hard-coding the NIC settings for speed and duplex helped.

-gbiello
 
Thanks for the input.

I already check service reset inbound, revers dns, and have everthing set to 100/full

I continue to have the same problem when moving data from my DMZ to the inside net.

Anymore ideas..
 

gbiello was right ! I went and double check NIC settings the firewall, FTP server and workstations were all 100/full but the switch port was not. Once I changed the swith port from auto to 100/full everything worked.

thanks for the advice.

-boczon
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top