Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SL2100

Status
Not open for further replies.

pete83uk

Systems Engineer
Feb 1, 2018
21
GB
Hi,

I have a NEC SL2100 configured with 5 SIP trunks (New Install), everything is working well, apart from the outbound calls receive a busy tone after a couple of seconds.

So the user, dials the external number, there is then a pause for a few seconds and a busy tone comes back.

Is there a setting that I missed on the outgoing side? SIP provider says it's not even attempting a connection.
 
Check the credentials in 10-28, 10-29, 10-23 if necessary. Make sure there are no spaces and caps is/is not needed in 10-36.
 
The sip provider that I have uses IP registration so none of these settings should be required?

Is there anything else that may be missing?
 
Verify:
SIP Trunk Registration Mode – via IP address

10-28-05, must be set to IP address
10-29-01, enable for proxy server by ITSP
10-29-03, assign IP address of SIP proxy server provided by ITSP – same address used for registration
10/29/04, assign proxy port ie:5060
10-29-05, must be set to enable – ability to register to the ITSP
10/29/06, assign IP address of SIP registration server provided by ITSP
10/29/07, assign SIP registration port – ie:5060
10-29-14, carrier type
10-29-21, used for NAT translations
10-36-01, enable for registration
10-36-02, user ID in SIP invite set up message – outbound CID
 
This worked many thanks for your help.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top