Sip trunk outgoing route

[pabx1121]

Hi guys

On bcm50 6.0 what's the best outgoing route pattern to use so that all digits dialled regardless of length will be accepted by the trunk. I have tried the option all, 0 and 1 and selected all wild cards but I get (no route to destination) each time.

Cheers for your response

 

[curlycord]

You want to let the SIP Trunk setting do the absorbing of the Dest code and not the DialingPlan.
Also a past common mistake was to enter all 10 digits (0 1 2 3 4 5 6 7 8 9) in the Routing Table in SIP Trunking, instead it should be the same as the Dest code in DialingPlan

I use 2 digit dest codes because of the amount of SIP accounts I have...

Example when using 91 as a dest code:

Dialing Plan
-Route 091 uses BlocA/Public
-Dest code 91 uses Route 09, Absorb is set to 0
-PublicNetwork DN lenght - add DN 91 and length 13



SIP Trunking/Public/Routing Table
-AccountName/Destination Digits is 91

SIP Trunking/Public/Accounts/AccountName/Advanced/
-Outbound Called characters to absorb is set to 2


I have some account examples in the FAQ's here

=----(((((((((()----=

http://www.curlycord.com

Toronto, Canada

Add me to LinkedIN

 

[pabx1121]

cheers, please have a look at these settings on the attached pic

what does "no route to destination" mean

 

[curlycord]

Means a routing issue.

You have not showed your routes or any of the routing settings in SIP Trunking.
Why is your 9 DN length at 15?

Regardless, I suggest you try the exact steps I have mentioned.
If using 9 then just substitute 91 for 9.

=----(((((((((()----=

http://www.curlycord.com

Toronto, Canada

Add me to LinkedIN