SIP Trunk configuration on NEC SV8100 PBX

[azizgstest]

Hi All,

I'm newbie to this PBX System, Could you please help me with a step-by-step guide to configure a SIP Trunk in NEC SV8100.

Basically in the other end I will have an Asterisk based SIP Server, The SIP Trunk configuration has been done from Asterisk side but I don't know where to start from in NEC SV8100 ??

Any help on this is very appreciated.

Thanks in advance.

 

[PFD45]

I've never done it myself but this might help:

License:
IP Trunk Licenses Are Required For SIP TIE Lines (Feature code: 5001)

Hardware:
CPU with IPLA/B

Programming:
10-12-09 Set the IP Address for your IPLA/B.
84-26 Set the IP Address for your DSP Resources.
10-40-01 Enable IP Trunk Availability.
10-40-02 Enter the number of IP Trunks.
10-23-01 Enable System Interconnect.
10-23-02 Assign the IP address of the Remote System.
10-23-04 Dial Number (Enter the leading digit of extension numbers on remote site).
10-28-04 Enter a valid Extension Number.
11-01 Define the F/Routes (Extension Numbers of the Remote Site).
14-05 Place IP Trunks into own Trunk Group.
15-07 Assign CAP Keys to all Extensions.
22-02 Set all IP Trunks to "TIE LINES".
44-02-01 Assign Dialed Digits (F/Routes)
44-02-02 Set Service Type to F/Route.
44-02-03 Additional Data (Reference a F/Route table from 44-05).
44-05 Assign Trunk Group and MAX digits.

 

[azizgstest]

Hello,

Thank you very much for your answer.

Do you have an idea how to check the licences installed on the NEC SV8100 ?

Thanks

 

[PFD45]

After you connect with PCPro click on "Communications" then "Feature Activation".

 

[azizgstest]

Thank you .

I will check and keep you posted.

 

[azizgstest]

Hi again,


I'm stuck in step 3, as I get an Error when trying to apply the changes : "There were errors when trying to apply the changes"

Do you have any idea what can cause this ?

Thank you.

 

[MH02DN]

I had a somewhat similar problem with my SIP trunk configuration. It got resolved after I backed up the data, initialised the system and reloaded the data.

 

[80safrikan]

do you have the voip hardware ?