Hi ,
I have setup the sip trunk between mx-one (4.1 SP7) and cisco cme 9.0. We tried from both side and the calls not going through. I saw "Line Busy" on aastra phone display when I tried to call.We followed the setup guide for aastra mx-one 3.2 sip trunk to cisco. IP addresses are pingable each other and 5060 no blockage...can telnet. I am not sure what could be the issue. Can anyone advise if you have successfully configured before?
I have attached the aastra configuration and also the config guide from Cisco which we followed.
Thanks!
CISCO 8.5 with MX-One 3.2 SP3
ROCAI:ROU=103,SEL=7110000000000010,SIG=1111111000A1,TRAF=00151515,TRM=4,SERV=3110000001,DIST=30,DISL=128,NODG=0,BCAP=101100;
RODAI:ROU=102,TYPE=TL66,VARI=00000000,VARO=00000111,VARC=00000000,FILTER=NO;
RODDIEST=8868,ROU=102,ADC=170700000000025010700110100 0,TRC=0,SRT=1,NUMACK=0;
sip_route -set -route 102 -uristring0 "sip:?@10.231.67.11" -accept ALL
ROEQI:ROU=102,TRU=1-1;
I have setup the sip trunk between mx-one (4.1 SP7) and cisco cme 9.0. We tried from both side and the calls not going through. I saw "Line Busy" on aastra phone display when I tried to call.We followed the setup guide for aastra mx-one 3.2 sip trunk to cisco. IP addresses are pingable each other and 5060 no blockage...can telnet. I am not sure what could be the issue. Can anyone advise if you have successfully configured before?
I have attached the aastra configuration and also the config guide from Cisco which we followed.
Thanks!
CISCO 8.5 with MX-One 3.2 SP3
ROCAI:ROU=103,SEL=7110000000000010,SIG=1111111000A1,TRAF=00151515,TRM=4,SERV=3110000001,DIST=30,DISL=128,NODG=0,BCAP=101100;
RODAI:ROU=102,TYPE=TL66,VARI=00000000,VARO=00000111,VARC=00000000,FILTER=NO;
RODDIEST=8868,ROU=102,ADC=170700000000025010700110100 0,TRC=0,SRT=1,NUMACK=0;
sip_route -set -route 102 -uristring0 "sip:?@10.231.67.11" -accept ALL
ROEQI:ROU=102,TRU=1-1;