Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

show run command

Status
Not open for further replies.
brooze

brooze

Technical User
Feb 17, 2003
12
0
0
RO
Dear all,

I type show run in my router in the previlige mode but I get nothing,

What can I do?

May be the memory is full?
Any suggestion?

Thanks
 
Sort by date Sort by votes
Are you an the enable prompt? router>
What privilage level do you have?
Can you do a 'show tech-support'

Good luck SF18C
CCNA, MCSE, A+, N+ & HPCC

"Tis better to die on your feet than live on your knees!"
 
Upvote 0 Downvote
Do you have any other problems with any other commands? you are at the rouer# CLI right?

anyways ,if you have problems with your imput or output it may be a hyperterminal configuration. I would try a win98 box. worked for me. I was using XP and getting mixed messages from some of my routers.
 
Upvote 0 Downvote
I have encounted same problem because router's free DRAM is not enough.It was solved after I reload the router.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

BleuBell
  • Locked
  • Question
Command Rejected : Exceeded NNI ports Allowed
Replies
0
Views
53
BleuBell
BleuBell
dogg1
  • Locked
  • Question
CUCM SNMP Set Command
Replies
1
Views
97
whykap
whykap
NavinNet
  • Locked
  • Question
Why 2 different mac addresses of a server are being shown of CISCO 6509E Layer-3 Switch ?
Replies
0
Views
43
NavinNet
NavinNet
atascoman
  • Locked
  • Question
3750 to 3850 QoS commands
Replies
1
Views
66
ADB100
ADB100
chieftan
  • Locked
  • Question
PE to CE running IPv6
Replies
1
Views
64
chieftan
chieftan

Part and Inventory Search

Sponsor

Back
Top