Short Call Time...

[Devanam]

My Company has two MD110s. One is BC11, the other is BC12. I'm trying to tie a trunk between the two. I have made the BC11 MD110 Master, and the BC12 MD110 Slave.

My issue is that when the master MD110 calls the slave, the call only stays up for about 5 - 10 seconds. But, when the slave calls the master MD110, the call stays up until you terminate it.

My Route programming looks like this...

Master MD110 BC11:
RODAI:ROU=**,TYPE=SL60,VARC=00000310,VARI=15480000,VARO=06310000;
ROCAI:ROU=**,SEL=7110000000000010,SIG=011100000031,TRAF=03151515,TRM=4,SERV=3110000011,DIST=30,DISL=128,NODG=0,BCAP=111111;

Slave MD110 BC12:
RODAI:ROU=**,TYPE=SL60,VARC=00000310,VARI=15480000,VARO=06410000;
ROCAI:ROU=**,SEL=7110000000000010,SIG=011100000031,TRAF=03151515,TRM=4,SERV=3110000011,DIST=30,DISL=128,NODG=0,BCAP=111111;

Can someone please help me?

Thank you in advance.

 

[HIREI]

Hi,
imho, there's 2 ways:
1) Think or wait for an expert answer;
2) Use protocol analyzer or trace the call by means of MD110 + decoder from SAM Tools. This will clearify the problem.

 

[trrep]

hi,

does the phone ring in BC12 if you start the call from bc11?
or is the line in BC11 only busy for 5-10 sec.?

normaly a signaltrace will show the reason for the behavior.
but maybe a restart of slp60,tlp60 and dtr in the bc12 lim can solve the problem too. at least as temporary solution.
in bc12 are different times problems with busy isdn lines. maybe thats your case too. with the newest SP in BC12 this problem should not be there.

best regards