Setting up RRAS

[CPaul123]

I am trying to setup RRAS on a second server. I already have one running and under the IP Routing section there is a subsection called General. It has 3 properties: Loopback (127.0.0.1), Local Area Connection (10.13.1.20), and Internal (10.13.1.200). However on my second RRAS box I am not able to configure the Internal part of it. I am having problems and I think this has to be configured with the first address of the assigned addresses.

Any information would be greatly appreciated.

Thanks

 

[hewissa]

How many nics in the second RRAS server?

Hewissa

MCSE, CCNA, CIW

 

[CPaul123]

Just one...The first RRAS box has 2 however only 1 is configured and plugged into the network.

 

[hewissa]

Install a second nic in server two.

Hewissa

MCSE, CCNA, CIW

 

[CPaul123]

Im looking at server one. Where do you configure the IP address for the internal?

 

[hewissa]

Check the properties of the nic in my network places. The ip assignment is made there, and viewable in the RRAS configuration.

Hewissa

MCSE, CCNA, CIW

 

[CPaul123]

I only see one nic and that is configured for my local area connection (10.13.1.20). The address that I see for the internal is the first address of my static address pool from the IP properties.

 

[hewissa]

The internal interface, or internal connection is a virtual interface that RRAS assigns. RRAS uses the interface named "Internal" as an endpoint for the incoming RAS connections.

As far as I can tell, the Internal Interface cannot be configured manually. It is automatically assigned an IP from your static pool or DHCP Server.

Hewissa

MCSE, CCNA, CIW

 

[CPaul123]

The IP addresses are static, starting from 10.13.1.216 -.221
and I dont know why that the internal interface isnt 10.13.1.216. I cant find any differences between server one and this one?

 

[MEL33]

I am currently having the same issue, did you find a fix for this?