Hi folks,
I need some help with some steps to setup a non-ISDN T1 trunk on my Avaya Aura CM using MG450.
The trunk is to connect to a customer PBX to allow a channelized trunk to pass 3khz voice lines to use my switch as a gateway to place external calls.
I tried setting up a ISDN PRI, but it wasn't working and they insist that their end is straight T1 (non-ISDN). Thank you.
I need some help with some steps to setup a non-ISDN T1 trunk on my Avaya Aura CM using MG450.
The trunk is to connect to a customer PBX to allow a channelized trunk to pass 3khz voice lines to use my switch as a gateway to place external calls.
I tried setting up a ISDN PRI, but it wasn't working and they insist that their end is straight T1 (non-ISDN). Thank you.