Setting Up a New Phantom Loop

[Watsonj]

I am trying to set up a new phantom loop on a Opt 81 running 4.5. We have two phantom loops that are fully utilized - Loops 148 and 152. Loop 156 is being used for VOIP. I tried to create a phantom on loop 144.

Two questions:

1) I am building loop n144 as a Quad Density loop in LD 17 (TERQ prompt). Is this correct?

2) I recieve a 'PHANTOM LOOP 144 IS ENABLED' message after I create the n144 in LD 17. But when I go to LD 97 and enter N144 at the SUPL I get an error SCH5739 -

"Cannot define that superloop. Some internal loops already exist as regular loops. Remove all TNs and route numbers for the four loops higher than the new superloop. For example, to add superloop 4, old 4, 5, 6, and 7 must be
undefined."

I have checked my CEQU and I have verified there are no loops 144, 145, 146, 147. Any ideas on what I am missing?



CEQU:

CEQU
MPED 8D
TERM
REMO
TERD 040
REMD
TERQ N144
REMQ
SUPL 004 008 020 028
036 044 072 088
N148 N152 V156
SUPC
SUPF
XCT 000 016 032 048
TDS * 000 * 016 * 032 * 048
CONF * 001 012 014 * 017
* 033 * 049
MFSD * 000 * 016 * 032 * 048

DLOP NUM DCH FRM TMDI LCMT YALM TRSH
PRI 002 24 ESF NO B8S FDL 00
003 24 ESF NO B8S FDL 00
018 24 ESF NO B8S FDL 00
019 24 ESF NO B8S FDL 00
024 24 ESF NO B8S FDL 00
025 24 ESF NO B8S FDL 00
026 24 ESF NO B8S FDL 00
027 24 ESF NO B8S DG2 00
034 24 ESF NO B8S FDL 00
035 24 ESF NO B8S FDL 00
MISP
EXT0 3PE
CNI 009 000 000
CNI 009 001 001
CNI 010 000 002
EXT1 3PE
CNI 009 000 000
CNI 009 001 001
CNI 010 000 002
MCFN 509 MB

 

[PERRYPJ]

No take that out you only build it in LD 97

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[Watsonj]

That did it.

Am I not remembering the procedure correctly or did something change?

 

[PERRYPJ]

Thats the way its always been

OLD ROLMEN WORKING ON NORTELS AND AVAYA