Set up Multi link PPP WAN serial interfaces ???

[Johnthom]

Hi all,
I have a router connected to my ISP with speed of 2 Mbps, but now I would like to upgrade the speed to 4 Mbps, I don't have modem supporting high speed like that. So I intend to use two 2-Mbps-modems and configure my router with multi-link PPP mode. Please tell me how to configure my router to group two serial interfaces into an IP address to deal with this issue.
Thanks very much for help.
John Thom

 

[Johnthom]

Hi,
I have just found out myself the document on this issue at the link :

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t3/multippp.pdf

If anyone has the same my question, please go to this link and get it, or if you have other better documents, better opinions, please share them with me . I always highly appriciate any opinions.
John Thom

 

[awadood]

Hi ,

Interesting issue . However , I doubt about load balancing once you have the two links . porbably you need to assign a diffrent gateway before accessing the ISP .

Good Luck .

 

[awadood]

Hi again ,

Sorry when I said I doubt about load balancing I meant in the situation that you have two modems connected to diffrent routers . but if they are connected to one router load balancing will be not an issue .

Have a nice time .