Service Pack 8

[ntTech50]

I'm updating the signaling service pack on a CPDC Signaling Server.

I downloaded SP8 and saw that the 4 lose patches were included in the zip file. I know that I need to install these four patches before the SP. I also know you have to rename the SP with .ntl

My questions is this: Do I need to remove them (four lose patches), and zip the patches back up without these 4? Or can I just upload the SP as it was downloaded from the PLDS (after loading the 4 lose patches and renaming the file to SP_7.6_8.ntl)?

 

[bignose21]

You put the 4 patches across and load them at CLI, with the SP leave it as is, the Patches are just seen as not required during the SPINS so process just steps past them.