I have a PRI that is down,CSU in CS1000 room shows a red ais alarm.
When I unplug the patch cable from Telco's Westell unit and plug it into my loopback plug back towards the CS1000 the CSU and the CS1000 goes normal,no alarms.
After going through the CS1000 with my engineer for 2 hours we have come to the conclusion that something in the C.O. is causing the problem.
My question is,am I missing anything or is Telco up to it's same old tricks ?
Two visits from Telco techs say they test "all ones",I am trying to get this fixed because the primary is slipping.
Any thoughts would be appreciated
When I unplug the patch cable from Telco's Westell unit and plug it into my loopback plug back towards the CS1000 the CSU and the CS1000 goes normal,no alarms.
After going through the CS1000 with my engineer for 2 hours we have come to the conclusion that something in the C.O. is causing the problem.
My question is,am I missing anything or is Telco up to it's same old tricks ?
Two visits from Telco techs say they test "all ones",I am trying to get this fixed because the primary is slipping.
Any thoughts would be appreciated