Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

scsi controller configureation trouble

Status
Not open for further replies.

rakishoner

Technical User
Aug 22, 2002
36
US
System specs:
ARCH: Sun Sparc e450
OS: Solaris 10
HW: SCSI Controller
lsi22802[/blue]

***Thanks for looking into my problem. Any and all help is welcome!

***My problem is with the above listed scsi controller. In my shell I execute the following commands and the returned out put is shown below.

Code:
# cfgadm -al
Ap_Id                          Type         Receptacle   Occupant     Condition
c0                             scsi-bus     connected    configured   unknown
c0::dsk/c0t0d0                 disk         connected    configured   unknown
c0::dsk/c0t1d0                 disk         connected    configured   unknown
c0::dsk/c0t2d0                 disk         connected    configured   unknown
c0::dsk/c0t3d0                 disk         connected    configured   unknown
c1                             scsi-bus     connected    configured   unknown
c1::dsk/c1t6d0                 CD-ROM       connected    configured   unknown
c1::rmt/0                      tape         connected    configured   unknown
c2                             scsi-bus     connected    unconfigured unknown
c3                             scsi-bus     connected    unconfigured unknown
# cfgadm -c configure c2
# cfgadm -l
Ap_Id                          Type         Receptacle   Occupant     Condition
c0                             scsi-bus     connected    configured   unknown
c1                             scsi-bus     connected    configured   unknown
c2                             scsi-bus     connected    unconfigured unknown
c3                             scsi-bus     connected    unconfigured unknown
# cfgadm -c disconnect c2
WARNING: Disconnecting critical partitions may cause system hang.
Continue (yes/no)? y
# cfgadm -c connect c2
# cfgadm -c configure c2
# cfgadm -al
Ap_Id                          Type         Receptacle   Occupant     Condition
c0                             scsi-bus     connected    configured   unknown
c0::dsk/c0t0d0                 disk         connected    configured   unknown
c0::dsk/c0t1d0                 disk         connected    configured   unknown
c0::dsk/c0t2d0                 disk         connected    configured   unknown
c0::dsk/c0t3d0                 disk         connected    configured   unknown
c1                             scsi-bus     connected    configured   unknown
c1::dsk/c1t6d0                 CD-ROM       connected    configured   unknown
c1::rmt/0                      tape         connected    configured   unknown
c2                             scsi-bus     connected    unconfigured unknown
c3                             scsi-bus     connected    unconfigured unknown

***At a loss here.

***Thanks in advance for some guidance.!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top