rakishoner
Technical User
System specs:
ARCH: Sun Sparc e450
OS: Solaris 10
HW: SCSI Controller lsi22802[/blue]
***Thanks for looking into my problem. Any and all help is welcome!
***My problem is with the above listed scsi controller. In my shell I execute the following commands and the returned out put is shown below.
***At a loss here.
***Thanks in advance for some guidance.!
ARCH: Sun Sparc e450
OS: Solaris 10
HW: SCSI Controller lsi22802[/blue]
***Thanks for looking into my problem. Any and all help is welcome!
***My problem is with the above listed scsi controller. In my shell I execute the following commands and the returned out put is shown below.
Code:
# cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 disk connected configured unknown
c0::dsk/c0t1d0 disk connected configured unknown
c0::dsk/c0t2d0 disk connected configured unknown
c0::dsk/c0t3d0 disk connected configured unknown
c1 scsi-bus connected configured unknown
c1::dsk/c1t6d0 CD-ROM connected configured unknown
c1::rmt/0 tape connected configured unknown
c2 scsi-bus connected unconfigured unknown
c3 scsi-bus connected unconfigured unknown
# cfgadm -c configure c2
# cfgadm -l
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c1 scsi-bus connected configured unknown
c2 scsi-bus connected unconfigured unknown
c3 scsi-bus connected unconfigured unknown
# cfgadm -c disconnect c2
WARNING: Disconnecting critical partitions may cause system hang.
Continue (yes/no)? y
# cfgadm -c connect c2
# cfgadm -c configure c2
# cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 disk connected configured unknown
c0::dsk/c0t1d0 disk connected configured unknown
c0::dsk/c0t2d0 disk connected configured unknown
c0::dsk/c0t3d0 disk connected configured unknown
c1 scsi-bus connected configured unknown
c1::dsk/c1t6d0 CD-ROM connected configured unknown
c1::rmt/0 tape connected configured unknown
c2 scsi-bus connected unconfigured unknown
c3 scsi-bus connected unconfigured unknown***At a loss here.
***Thanks in advance for some guidance.!
