Scheduled Patches not loading

[BogeyShooter]

I have a BCM400 that was upgraded from 3.7 to 4.0 in 2007. I am trying to load several software patches. I set the schedule up to load the patches after hours, allowing for the time to load the patch and the time to reboot, but only one of the patches applied, the others show scheduled.

The one that applied was the last one on the schedule. I double checked the times and dates and everything was correct.

Has anyone else run into this?

 

[CyberX666]

Yup, i have had the same problem. Also on BCM50 rls1/2 and 3. I now only schedule 1 patch at a time and works fine. I have not seen any fixes for this issue as yet.

 

[BogeyShooter]

Thanks, I'll try that.

 

[SupportDude]

If your applying from a "desktop", you can only apply 1 patch per schedule.
You can schedule multiple patches if you use an FTP or shared network folder.

-SD-

http://www.mysupportguy.net

 

[BogeyShooter]

I loaded them from my laptop onto the BCM (took my laptop home) only 1 patch loaded.

 

[SupportDude]

Right.
So you would have selected from "My Computer" to get the patch.
That method only allows one patch.
I assume its an issue with storage on the BCM50 HDD.

-SD-

http://www.mysupportguy.net