No errors reported but the current job seems to be stalled, Status is Running, Byte count equates to about 20%, when I try to cancel, the job freezes, and I have to reboot the server to clear the job.
Any idesa?
Semaphore timeout messages have to do with the communication between the tape device (through the driver) and the software or OS.
You may want to check the SCSI card parameters:
1) Try turning off the "initiate sync negotiation" option for the SCSI ID of the tape drive if it is currently on.
2) Set the SCSI ID for your drive to a low number (SCSI ID 3 is a good rule of thumb).
3) Set the "sync transfer rate" for the SCSI ID of the tape to the lowest setting possible (but don't use ASYNC, or asyncronous).
Once those settings are in place, try changing the tape device driver. If you are using the ones from the hardware vendor (HP Surestore, etc..) try installing the drivers that come with BE.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.