Hi,
I'm hoping there is an easy answer to this. I have a dell dimension 5150, with the 0wg261 motherboard, intel 945G chipset, BIOS version A02, and 160gb sata150 seagate HD. To the best of my knowledge, I have installed all pertinent drivers, and I am using the onboard SATA controller - However in the device manager, my primary IDE properties are showing as Ultra DMA mode 5 -- Which as I understand it is the equivilent to ata-100, far below SATA150 1.5Gbs speed. I understand the onboard SATA supports SATA150, but I don't think I'm there. I also think I've set all nessessary BIOS settings correctly..
Anybody help!?
I'm hoping there is an easy answer to this. I have a dell dimension 5150, with the 0wg261 motherboard, intel 945G chipset, BIOS version A02, and 160gb sata150 seagate HD. To the best of my knowledge, I have installed all pertinent drivers, and I am using the onboard SATA controller - However in the device manager, my primary IDE properties are showing as Ultra DMA mode 5 -- Which as I understand it is the equivilent to ata-100, far below SATA150 1.5Gbs speed. I understand the onboard SATA supports SATA150, but I don't think I'm there. I also think I've set all nessessary BIOS settings correctly..
Anybody help!?