S8500 Add LSP

[1148tr]

I have a G350/S8300 CM 3.1.4 LSP that I want to add on the S8500 CM 3.0.1 but the only commands available are display and change lsp. I have used add survivable-processor in the past with CM 3.0. Is change lsp the proper command or do I have a licensing issue? Thanks.

 

[98Converter]

Did you add it in your node-names?

Thanks,
CJH

We are what we repeatedly do. Excellence, then, is not an act but a habit. ARISTOTLE 384-322 B.C.

 

[1148tr]

This seems to be the correct command. When did it change to add survivable-p? I did get it to register/go in-service once and it stated that the translations were sent but the login and passwords were never sent - I could not log in with the same login on the S8500. Unplugged the network cable and it did not switch to LPS mode...had no dialtone at that point.

 

[1148tr]

This looks like the correct command, when did it change? I did get it to register/go in-service once and it says translations were sent but I don't think that was the case since I could not log using the same login I use for the S8500. When the network cable is unplugged it does not switch into LSP mode and I have no dial tone.

 

[1148tr]

Yes, it is in the node-names list and it was registered once.

 

[1148tr]

It is in the node-names list.

 

[1148tr]

It is in the node-names list. Thanks.

 

[1148tr]

Sorry, I thought the replies were not going through so I replied multiple times. I am too impatient.