S8400 / G650 with Media Gateway G350 Remote Non LSP

[rigbyk]

Ok - Here's my problem.

I have a S8400 with a G650 that is connected to a remote G350 that is not Survivable / LSP. I have the link up and I can successfully TTI stations at both locations.

When I try to call from one TTI'd station to the other I get a "no resources available" message on my display phone.

I think this is a medpro issue - what did i do wrong? Any suggestions?

 

[Ronster]

Do you have medpro's at both locations?

Ronster
"If you’re too open-minded, your brains will fall out.

 

[rigbyk]

no there's a medpro in the 650 - not in the G350

 

[Mitch672]

sounds like you may not have correct default gateways on the G350 or MEDPRO, or you don't have your ip-network-regions or codec sets setup correctly...

can you ping from the G350 the MEDPRO and CLANs, and from the S8400, can you ping the PMI of the G350? if you can checkout your IP-Network-Regions and IP-codec sets, also you might want to check your IP-Network-Map, if you have ip phones. Also check to see if your G350 is administered in its own ip-network-region, and check to see if your MEDPRO is in its own region as well.. there can be a lot of things to check, but basiclly the switch is telling you "hey, I can't get the VoIP packets from here to the main switch"

mitch


AVAYA Certified Specialist

 

[rigbyk]

Thanks Mitch - it was my ip-network-region - i forgot to set the codec for region 2 (WHOOPS!)

So many little things to remember!