RVA BC8.1 on PABX GH

[rekrab]

Well,

I have been trying to set up a RVA card on a BC8.1 site for the past 5 hours now and will it work NO. Anyone any ideas what I am doing wrong. It looks like BC8 is very hard to set up as there are a load of AS parameters to set up. I think I have done these ok.

I have the VSU card installed fine and 3 messages recorded MSG1, 2 & 3. but I cannot seem to relate these messages to the Group Hunt. ALeX seems to concentrate on PABX operators and little on GH, but it says it can be done.

Anyone any ideas.

Many thanks.

 

[mdfan]

Try RAGAI:GRP=,WELCOM=,QUEUE=,REPQUE=;

 

[rekrab]

Thanks for replying duvel.

But this command does not exist at BC8. Only at BC9.

 

[whosrdaddy]

BC7 & BC8 RVA are controlled via SERV parameter of the group, more precisely D5-D9 :

D5 : provide queue repeat message (1)
D6-D7 : welcom announcement message (00 = no message)
D8-D9 : queue announcement message (00 = no message)

hope this helps,

http://www.damovo.com

 

[rekrab]

Thanks for your helps guys. I have figured it out. It was a ASPAC that I hadn't set correctly.