RRAS client Can't Browse Internet using Internet browser.

[jewenbp]

Please Help!.

Info:
1. win2k server(SP4) for single dial-in only not a NAT server.(I can
browse here with in my console server)
Lan:
IP Address: 192.168.0.5
Gateway: 192.168.0.150
DNS: 192.168.0.150

2. 192.168.0.150 is on Network and it acts as Firewall and a NAT and a
DNS and a Gateway running on Linux server.

After dialing-in on this rras server (win2k server (SP4):
1. I can ping

http://www.yahoo.com

- no problem
2. I can tracert

http://www.yahoo.com

- trace complete - no problem
3. I can also ping our local ip addresses - no problem.


Problem:
1. When i browse to the internet(

http://www.mircosoft.com)

using Internet Browser
i can't browse(no display)
2. i thought it was a dns problem so i tried to browse using this method

http://207.46.134.155

(

http://www.microsoft.com

ip address"sample only&quot and i still can't browse.
3. i also tried to configure my browser at Tools->internet
option->connection and still can't browse.
4. i've change some of the configuration on the RRAS and still can't browse
but no NAT install because this is not a NAT server.

Questions:
1.Any suggestions?
2. am i missing something here?
3. What is wrong with my configuration?

Thank you very much!

Jewen

 

[jonlutz]

Since you've verified it's not a DNS problem is it possibly a port problem. Perhaps your TCP/IP port that the browser uses (110 I think) is blocked.

 

[jewenbp]

Greetings Jonlutz,

Your comments is very usefull, i will check this but how can i check this or how to verify if it's block or not? if you don't mind. if the port (110)is blocked then why? i didn't used any firewall on the server side and the client side either.

thank you very much!

Best regards,
Jewen