Routing Trouble

[schlum]

Hello everyone,

I have a MICS with PRI and I am trying to build a route for outdialing. I have built Route 001 with a dial out of 9 and to use PRI-A. I have created destination code 9, have told it to use route 001, and when I go to Absorb Length, I am trying to set it to 1, but all it allows me to do is ALL or 00. Any ideas. Thanks.

Schlum

 

[schlum]

Sorry I tried everything with the destination and routing, adding digits, removing them, keeping them with nothing. Turned out that the PRI was only getting 7 digits sent through and then release the call. Turns out Pub DN Length was set to 7...changed to 10 and works fine now. Thanks

Schlum

 

[allworxguy]

Yes 7 digits is the default. If you ever call international set your public length to at least 16.

Local (with area code) 10
LD - 11
Int - 16

Marv

http://www.telemarv.ca

 

[exsmogger]

Absorb length only refers to the destination code, so you would set it to all if you don't want the 9 to be outdialed.

Brian Cox
Oregon Phone

http://www.OregonPhone.com

http://www.linkedin.com/in/briancox1952