Routing call though extention/premicell

[SPIPOffice]

any ideas on how i would go around this problem.

I have an ip office with 30 analoge extention. \the company has a 4 extention internet telephony gateway. Just like a pemicell but has 4 ports.

I now the unit works as when I dial the extention number, I breakout to another dial tone and can dial numbers out.

We want to route all 00 (international number) though the gateway.
Any ideas on how I would get more then 2 calls at a time though the gateway? the extention the gateway is connected to is 201,202, 203, 204.

Thanks

 

[telesonic]

What happens to the 3rd call? And have you watched it via call status and monitor tracings?
Do you have the calls go to a group and hunt through 201;202;203;204?
Paul

 

[Morrack]

Change the 4 port FXO card in the ITG to a 4 port FXS card instead and plug into analog trunk ports on the IPO and you can use line groups, shortcodes and LCR just like regular lines. In other words, you can setup a UDP (uniform dialing plan) and it works really slick. I've done this sort of thing before when the customer won't spring for a VCM - as you know the ITG is cheaper.

For incoming calls on those trunks send them to a VMPro module that allows the ITG to dial the extension required, and play with the dialout timing paramaters in the ITG to get it right.

Peter

 

[xlr8neo]

first you can set up a short code ie 00N
Under telephone number put 201D,,,.
Feature should be dial extn
this will allow you to dial 00 for int calls
the telephone system will dial extn 201 wait for 3 seconds
and then dial the full no. you will need to turn of cli on the extn 201 to 204.
if this works then create a station group set to hunt group and change the short code to point to the group