I just took over management of a LAN with the following subnet 10.10.10.0, with a gateway of 10.10.10.1, used as a VPN gateway to other networks. The devices on the existing network needs to communicate to one computer that's in a new subnet that I'm implementing, 192.168.0.0. The computer has the ip address 192.168.0.100 and the cisco router's ip is 192.168.0.1. The third interface on the cisco will have ip 10.10.10.2 so it can connect to the existing subnet.
I don't have access to the VPN gateway on the existing network, we would like to leave that alone.
I'm thinking of changing the gateway ip address of the devices on the existing network to 10.10.10.2. Add two static routes:
ip route 192.168.0.100 255.255.255.0 FastEthernet0/0 (which is 192.168.0.1)
ip route 10.10.10.0 255.255.255.0 FastEthernet0/1 (which is 10.10.10.2)
Is this the best method? Any comments or suggestions? TIA
I don't have access to the VPN gateway on the existing network, we would like to leave that alone.
I'm thinking of changing the gateway ip address of the devices on the existing network to 10.10.10.2. Add two static routes:
ip route 192.168.0.100 255.255.255.0 FastEthernet0/0 (which is 192.168.0.1)
ip route 10.10.10.0 255.255.255.0 FastEthernet0/1 (which is 10.10.10.2)
Is this the best method? Any comments or suggestions? TIA