routers look right but dont work

[picnmix]

Hello,
We have a problem getting http to work over our wan links. Ping works etc.. but http doesn't. This is the setup


O--------o---o---------0
scot birm telford

we have a cisco 1700 at telford and at birmingham, connected over lease line. also in the birmingham office we have a draytec 2600 connected to scotland via ADSL and VPN. Scotland also has a draytec 2600. we have enabled rip v1 on all routers and this seems to be fine I can ping scotland from telford and I can RDP machines in scotland. However when I try to connect to the draytec router in birmingham or scotland from telford nothing happens.

any ideas

Picnmix

 

[Ru55ell]

Is HTTP enabled? Can you telnet?

 

[KiscoKid]

Check your firewall rule set on the Draytek's and any access lists on the Cisco routers for denying http traffic.

 

[plshlpme]

are you using classfull networks at all of your sites?
if not you will have routing problems with ripv1.

 

[doublea1535]

Attempt to telnet on port 80 and note the error message you receive (if any). For more verbose output on the state of a port use a port scanner like nmap