Route Problem in 2000IPS

[FlavioMiranda]

Hi ,

I have a route in my 2000IPS with 12 analogic trunks. is the route 00. But, after this 12 truks have been used , the PABX try to access other trunks.
My LCR is :

COMMAND=8A0006
8A0006>1
8A0006>1:00600-
8A0006>2:NONE-
8A0006>3:NONE-
In others words, the PABX should access only the trunks contained on route 00.
Anybody know what happen?
thanks in advanced!

 

[peporter]

Check out the following command and see what trunks you have access to from Route 00 - trunks 100~107 are examples only.

CM3000>100~107>00 Assign Trunks (100~107) to a Trunk Route (00). Unused trunks should be assigned to a dummy trunk route. E.g. 63.


Phillip E. Porter
Senior Systems Engineer
VA Medical Center Louisville Kentucky
Telecommunication Solutions Group, Inc. (TSG)

 

[FlavioMiranda]

Here they are?
COMMAND=3000
3000>000
3000>000:00-
3000>001:00-
3000>002:00-
3000>003:00-
3000>004:00-
3000>005:00-
3000>006:00-
3000>007:00-
3000>008:00-
3000>009:00-
3000>010:00-
3000>011:00-
3000>012:00-
3000>013:00-
3000>014:00-
3000>015:00-
3000>016:01-
3000>017:01-SIP TRUNK
3000>018:01-SIP TRUNK

The problem came after that I began to configure my SIP trunks!!!!!
Thanks a lot!

 

[peporter]

If you only have 12 Analog trunks and their trunk numbers are 000~011 then you need to change the routes for 012~015 to a dummy route, e.g. 63. Make sure that the 12 trunks are connected to 000-011 on your patch panel or MDF. If the trunks are attached to for example 002-013 then you need to change the route for 000-001 to 63. and leave 002-013 at 00.

Phillip E. Porter
Senior Systems Engineer
VA Medical Center Louisville Kentucky
Telecommunication Solutions Group, Inc. (TSG)