Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Route-pattern between CM5.1 and stand-alone CME?

Status
Not open for further replies.

atod

IS-IT--Management
Jan 5, 2007
4
US
I would like to establish 4 digit dialing between the CM5.1 and CME but not exactly sure how to configure the RP. Both CM5.1 and CME router can ping each other.
 
We are using H323. I added the CME H323 gateway to the CM and created a RP 78XX, now I 4 digit dialing from CM phones to CME phones but not vice-versa. How do i setup the CME gateway to communicate w/ the phones reqistered to the CM? If possible, I want the CME to be stand-alone to avoid further upgrade/re-configuration of the CUE voicemail.
 
Assuming CCM extensions are 56XX

dial-peer voice 22 voip
destination pattern 56..
session-target ipv4:<ip address of CCM>
forward digits 4

Should be close. Doing this from memory.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top