Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Rogers CLID and CPND on PRI

Status
Not open for further replies.

Pbxpoweruser

IS-IT--Management
Jul 16, 2007
239
CA
Hi,
I am having an issue where since I migrated to Rogers PRI, the CPND is no longer sent out. Anyone else have this issue?
 
Are you talking about sending out the CPND name in LD 95? If so the only way that might have even worked is if you were connected to a DMS and I doubt that worked. More than likely your old Vendor was tagging all the outbound calls with a generic name.
 
Yes you can send the name out and this if programmable per CLID Entry in LD 95 (As of RLS 5). The issue was that when using an ESS5 switch you must put NDS i the OPT field.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top