RODDP:dest=all;

[splick]

hi,
I am new to this forum and new to the MD110. Have MD110 with 3 lims and wish to extend an extensions range to a route. So when I run rdoddp:dest=all; my extensions starting 292*, 293*, 294*, 295* go out over route 8.
How do I add extension range 296*,297*, 298*, 299* to also go out over route 8.
Any help greatly appreciated

splick

 

[rfpup]

How do you chechk it?Is there any cust in the print out form of roddp?
If yes Check with ksddp or exddp if the above extensions are part of the same cust (customer)
If yes kscuc or excuc to the needed extensions with the same cust.

 

[splick]

The output is below and these are 5 digit extensions and I just want to add the ranges 296,7,8,9, and put them over route 8. I need to know the commands to do this if anyone knows. cheers

roddp:dest=all;
EXTERNAL DESTINATION ROUTE DATA


DEST DRN ROU CHO CUST ADC


292 8
293 8
294 8
295
6999 2
9 1 0005000000000250000000000

 

[whosrdaddy]

nansi:numse=296,numtyp=ed;

roddi:dest=296,rou=8;

rinse and repeat for other destinations.



-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[splick]

All I can say is You Sir Are The Daddy.

thanks very much for the help, this is for a ipt trial as looking at Cisco, Nortel, Ericcson IPT and need to force these ext over the Qsig link. thanks again

 

[rfpup]

Hi splick!

I think your question was not quite well-explained.
Perhaps you meant when dialing from your system towards the numbers begining with 296, 297, 298, 299 call has to go out through route 8 which is a QSIG route with any of the other systems, so these extension are part of the other system.
Am I right?