RME Device Telnet attribute

[facaldo]

Hi,
I have a problem adding a couple of 2950G-EI switches to the RME, I cannot get the the telnet attribute to work. Every time I add the correct password attribute and check the status of the device I always get "not supported"....
any ideas
Thanks
Gary

 

[fmonteiro]

Are you able to Telnet to this device? When doing that are you using the same password as the one specified in the Device attibute? By your message I would believe that Telnet is not available to this device.

 

[facaldo]

sorry should have been more specific. yep, telnet is fine, snmp fine, connectivity is all ok. dns is correct, banging my head against a wall here. Only the 2950's are giving me these problems, I have no issues with 3550's 4500's and 6500's that we are managing.

any help appreciated.

Thanks
Gary

 

[fmonteiro]

What is the version of your RME? Is the 2950 series supported by your RME version?

Check the Supported Device List on CCO (

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/cw2000e/dev_sup/index.htm)

to see whether or not an upgrade to RME is required.

 

[bank69]

Open a ticket with the Cisco tac and get an IDU2.0 or 3 upgrade patch. We ran into this problem with different versions of IOS codes.