Ok, I'm about to pull my hair out on this one if anyone has any new ideas or old ones I haven't tried.
-I installed RIS on one of my DCs.
-Ran RISetup
-AD is set to respond to all client requests.
-I have authorized the RIS server in DHCP, and can see the
1045 event message that verifies that BINLSVC is
authorized.
-I have BOOTP and DHCP enabled on my scopes.
-The RIS server is on the same subnet as the clients so
there is no router.
-I have tried 3 different PCs (GW, Compaq, and Dell) with
the latest pxe rom versions
- We have tons of BOOTP and DHCP devices with valid addresses.
I just dont get it, if anyone has a tips.. please list it
Thanks
Shawn
-I installed RIS on one of my DCs.
-Ran RISetup
-AD is set to respond to all client requests.
-I have authorized the RIS server in DHCP, and can see the
1045 event message that verifies that BINLSVC is
authorized.
-I have BOOTP and DHCP enabled on my scopes.
-The RIS server is on the same subnet as the clients so
there is no router.
-I have tried 3 different PCs (GW, Compaq, and Dell) with
the latest pxe rom versions
- We have tons of BOOTP and DHCP devices with valid addresses.
I just dont get it, if anyone has a tips.. please list it
Thanks
Shawn